• Dexx1s@lemmy.world
    link
    fedilink
    arrow-up
    0
    ·
    3 months ago

    Isn’t almost any keyboard able to last that long?

    I make sure any motherboard I buy has at least 8 USB ports, so I know I’ll have enough. It does make sense to use the PS/2 port if you have the peripherals. What advantage does USB have over it anyway?

    • MerchantsOfMisery@lemmy.ml
      link
      fedilink
      arrow-up
      0
      ·
      3 months ago

      Isn’t almost any keyboard able to last that long?

      In theory, yes. In reality… not so much. Bluetooth keyboards are a joke for longevity, and a lot of wired keyboards these days just have piss poor build quality.

      I don’t think PS/2 inherently has major advantages over USB but as someone who uses a small PC with few USB ports, I appreciate having a PS/2 port available.

      • vaionko@sopuli.xyz
        link
        fedilink
        arrow-up
        0
        ·
        3 months ago

        I had a Razer Blackwidow keyboard, lasted only like 6 years before the switches started dying. Or it got into a cult. Sometimes pressing k would type out kkk.

    • offspec@lemmy.world
      link
      fedilink
      arrow-up
      0
      ·
      3 months ago

      Usb keyboards can have n-key rollover which let’s you press more buttons simultaneously, whereas PS2 has a hard limit of like 5 or so

      • drathvedro@lemm.ee
        link
        fedilink
        arrow-up
        0
        ·
        3 months ago

        It’s actually the other way around. Check out Ben Eater’s awesome videos for technical details.

        TLDR: PS/2 sends separate key up and key down events, sequentially - like #1 Down - #2 Down - #1 Up - #2 Up - each in separate message, allowing for theoretically infinite rollover (excluding certain edge-cases). USB, on the other hand, polls only for keys being pressed at the moment. By default, the keyboard responds with a 8-byte message, with 1 byte being the bitmask for 8 modifier keys (4 on each side), a spacer, and 6 bytes/slots for identifiers of keys being held down. If one identifier is present in one response but is missing or replaced in next one, the system assumes a key-up event. It is possible by USB spec to negotiate connection in such a way that the keyboard responds with a bitmask for every single key it has. But this is not well supported by things like BIOS and KVM’s, so very few keyboard manufacturers bother implementing it. Most keyboarrds advertising NKRO are actually only capable of doing so via the PS/2 adapter.

    • vortic@lemmy.world
      link
      fedilink
      arrow-up
      0
      ·
      3 months ago

      I go through a cheap Logitech keyboard just about once every three years. I replace them when a a couple of keys stop working or when the nubs wear off of the center keys and can no longer blindly find where my hands go.